LCM5N 5 Inch Navigation Monitor
LCM58N 5.8 Inch NavigationMonitor
with
1 Video Input Capability
Operation Manual
AUX Cable
AUX Cable
(External VCR device connection wire)
1) Type of Cable : Two RCA to One Stereo Cable.
-3-
OSD Menu Structure
Monitor Panel Control
( - button )
( + button )
-4-
On Screen Display
This page describes the function of the control keys and the OSD menu
structure.
The relevant menu (video or nav) will be detected automatically, depend-
ing on the input mode given by the display control line or by VCR-
connector.
Monitor Settings
The color display is equipped with On-Screen Display (OSD)
prompting for the monitor settings.
There are 3 buttons on top of the monitor.
These will be used for the OSD control. They are as follows:
“Menu” = Menu
“ + “ = Plus
“ – “ = Minus
“Menu” button is used to select the desired function.
The desired function will be highlighted in red.
“+” And “-“ buttons are used to adjust the desired function.
Note: If a button has not been pressed for 5 seconds, then the
OSD menu is automatically hidden again.
-5-
Invoking OSD menu
Briefly press the menu button on top of the monitor.
The OSD menu “ Navigation settings” is displayed and
Volume will be highlighted in Red.
In the OSD menu you can adjust the following settings:
* Volume:
Adjust Volume level of the built-in
monitor loudspeaker
* Brightness:
* Display mode:
Adjust brightness of the display.
Screen display; the selected setting
is indicated in red.
Possible selections include:
“Full Screen “ (16:9)
“Normal” (4:3)
Adjusting settings
1 . Press the Menu button until the desired function appears
in red.
2 . Adjust the desired setting with the + or – buttons.
If necessary, invoke the next menu item by pressing the
Menu Button.
-6-
* If you use the built-in monitor loudspeaker, leave
the volume level in the OSD menu on the middle
setting. Adjust the volume level for the audible
messages of the navigation system with the + or –
buttons on the remote control.
* The volume level of the built in monitor speaker can
also be set without invoking the OSD menu. Press the +
or – button on the monitor. The display automatically
changes to the menu for setting the volume. Set the
volume desired by pressing the + or – buttons.
Set up Menu
The monitor offers you the possibility of performing the following
settings in the Setup Menu:
* Brightness Control: Day/Night
* Loudspeaker:
On/Off
-7-
Invoking the Setup Menu
Press all three buttons at the top of the monitor at the same
time.
The Setup Menu appears
Brightness will be highlighted in red.
Press + or – to select Day or Night highlighted in red. Day
selection will be bright, Night will be dark.
Note: If brightness control is set for Night, It will return to Day
mode whenever the Ignition is turned off for more then 30
seconds.
1 . Press the menu button to highlight Loudspeaker in red
2. Press + or – button to select ON or Off.
- VIDEO MENU (AUX cable : Connection, Navigator cable : Connection)
* VOLUME : This function is used to control the audio volume.
* BRIGHTNESS : This function is used to control the overall
brightness of the picture displated on the monitor.
* COLOR : This function is used to increase or decrease the overall
color saturation of the picture displayed on the monitor.
* CONTRAST : This function is used to increase or decrease the
overall contrast of the picture displayed on the monitor.
* TINT : This function is used to increase or decrease the overall color
schme of the picture displayed on the monitor.
* DISPLAY MODE (NORMAL, FULL SCREEN, CINEMA) : Make
reference to 9 page.
.
-8-
Display Mode
1. Press MENU to get the On Screen Display (OSD).
2. Select Display Mode.
3. Press the + or the - to switch the screen aspect ratio.
FULL SCREEN: 16:9 picture is fully displayed.
CINEMA : Picture is displayed with uniform vertical enlargement.
NORMAL : When 4:3 pictured is displayed on a wide screen, black bands
appear on the right and left of the picture
-9-
MONITOR SPECIFICATIONS
Type
a-Si TFT Active Matrix LCD
Display Screen Size
LCM5N : 110.4(W) x 62.244(H)(mm)
LCM58N : 127.2(W) x 71.838(H)(mm)
1200(W) x 234(H)
Resolution
Pixels
LCM5N : 200(X), 117(Y) Center of display area
LCM58N : 200(X), 117(Y) Center of display area
CCFL with 3 ware-length spectrum
LCM5N : Straight Type
Back Light
LCM58N : U Type
Power Source
+12 Vdc
Power Consumption
LCM5N : 500mA 6W
LCM58N : 600mA 7.2W
Connection
1-Navigator Connection Wire
1-AUX Connection Wire
Operating Temperature -20oC ~ +70oC
Storage Temperature -30oC ~ +80oC
Monitor Cabinet
(without Packing)
Weight
LCM5N : 148(W) x 90(H) x 30(D)(mm)
LCM58N : 164(W) x 103(H) x 30(D)(mm)
LCM5N : 2.5K
LCM58N : 2.7K
Video Format
NTSC (Only)
-10-
For Customer Service
Visit Our Website At
Product Information, Photos,
FAQ's Owner's Manuals
Copyright 2004 Audiovox Electronics Corp., 150 Marcus Blvd., Hauppauge, NY 11788
128-7099
-11-
|